This kit module is similar to the red laser modules used in some low cost laser engraver projects, will engrave card/wood and cut thin paper.
These new 658nm open-can laser diodes can be driven at 3-420mA to give 250-350mW.
- New diode supplied fitted in module case.
- 3 element glass lens with 630-660nm (centre wavelength) anti-reflective coating for 9.0 x 0.5mm threaded laser diode housings.
- High current LM358 driver. This is a current regulating linear driver based on the LM358 chip with a high current transistor output stage. Requires a supply voltage around 1.5V higher than the operating voltage of the laser diode.
- See "Projects and Kit Guides" Tab for a copy of the instructions similar to those supplied (same build, different diode).
- Cable and solder not included.
Assembly requires soldering and a means to set the laser driver current (e.g. test load, variable power supply and multimeter). OFL520 meter kit is recommended.